CHOP CHOP INC BROKEN BRIDGE MINE GUIDE

To repair the broken bridge in the mine, chop the obstruction out of the lever mechanism, craft a cog wheel at the furnace, and install that wheel back at the bridge control. The recorded walkthrough uses four metal wood for the cog wheel. After the part is installed, the lever can operate the bridge.

Clear the Bridge Mechanism First

Approach the broken bridge and inspect the lever assembly rather than trying to cross immediately. The walkthrough shows an obstruction that must be removed with the axe before the mechanism becomes usable. Once it is cleared, interacting with the assembly reveals that a replacement cog wheel is needed.

Do this inspection before returning to camp so the repair objective is active and you know which component to make. The source does not describe an alternate route that skips the mechanism. Claims about another bridge or the mine shaft were filtered out because they did not address this specific repair.

Unlock the Furnace and Metal Wood

The recorded player already had the furnace unlocked and had access to metal wood. Those are practical prerequisites because the cog wheel was crafted through the furnace interface from that processed resource. If the recipe is unavailable, continue the progression that unlocks the furnace and metal-resource processing.

The exact quest or level that unlocks the furnace is not stated in the bridge material. Do not assume a number or unrelated quest requirement. That prerequisite remains not verified beyond the confirmed fact that the working walkthrough had both the furnace and metal wood available.

Craft the Cog Wheel

At camp, interact with the furnace and select the cog wheel recipe. The video shows four pieces of metal wood being inserted before the cog wheel is crafted. Confirm the requirement in your current recipe panel in case a later patch changes it.

This is the only exact material quantity supported by the collected bridge source. No screws, bars, or additional ingredients are shown for this particular cog wheel. Do not confuse it with the larger Cannon Quest crafting chain, which uses different metal components.

Install the Replacement Part

Carry the completed cog wheel back to the mine bridge and interact with the lever mechanism. Use the repair interaction to install the new component. The mechanism can then operate, providing access across the broken span.

The walkthrough briefly suggests that the repaired route may lead toward later metal-tool progression, but it does not document the full reward chain. Any precise claim about what is unlocked beyond the bridge is not verified. Treat the bridge opening itself as the verified result.

If the Repair Prompt Does Not Appear

Check that the obstruction was fully removed before trying to install the cog wheel. Then verify that the crafted part is in your inventory and that it is the cog wheel produced at the furnace. Returning with raw metal wood instead of the finished component will not complete the documented sequence.

If all three conditions are satisfied and the interaction still fails, compare your game version with the recorded walkthrough. The collected material does not provide a confirmed reset procedure or alternate installation point. Save-file-specific troubleshooting is therefore not verified.

Direct Answer

Clear the lever obstruction with your axe, use four metal wood at the furnace to craft one cog wheel, return to the mine, and repair the lever mechanism. That is the complete supported sequence in the collected video. Other mine and bridge claims were excluded because they did not match this location.